Packet data access points
Select
Menu
>
Ctrl. panel
>
Settings
and
Connection
>
Destinations
>
Access point
, and follow the
instructions on the screen.
To edit a packet data access point, open
one of the access point groups, and
select an access point marked with
.
Follow the instructions from your
service provider.
Select from the following:
Connection name — Define a name for
the connection.
Data bearer — You might not be able
to edit the data bearer once defined.
Define a new access point if needed.
Access point name — You obtain the
access point name from your service
provider.
User name — The user name may be
needed to make a data connection, and
is usually provided by your service
provider.
Prompt password — If you must enter
the password every time you log in to a
server, or if you do not want to save your
password in the device, select
Yes
.
Password — A password may be
needed to make a data connection and
is usually provided by your service
provider.
152 Settings
© 2010 Nokia. All rights reserved.
Authentication — Select
Secure
to
always send your password encrypted
or
Normal
to send your password
encrypted when possible.
Homepage — Depending on the access
point you are setting up, enter the web
address or the address of the
multimedia message centre.
Use access point — Select
After
confirmation
if you want the device to
ask for confirmation before the
connection using this access point is
created, or
Automatically
if you want
the device to connect to the destination
using this access point automatically.
Select
Options
>
Advanced settings
and from the following:
Network type — Select the internet
protocol type to transfer data to and
from your device. The other settings
depend on the selected network type.
Phone IP address (for IPv4
only) — Enter the IP address of your
device.
DNS addresses — Enter the IP
addresses of the primary and secondary
DNS servers, if required by your service
provider. To obtain these addresses,
contact your internet service provider.
Proxy server address — Enter the
address of the proxy server.
Proxy port number — Enter the port
number of the proxy server.